How to inspect your engine car
The engine is the most important element of a vehicle. However, there are times if not lucky, the engine can not be turned on even when the key is turned in the direction start. Possibility damage that could occur based on the symptoms, causes and repairs can be done. |
| Engine |
If there is a problem with the system initiator (starter), we need to learn how to start the engine when the battery and / or starter motor in a state of disrepair. When the engine can not be turned on as easily as the battery and / or starter motor in a damaged condition, the engine will usually start with the following procedure:
- Turn the engine by pushing the vehicle (for manual cars). While the battery is weak, the engine will be switched on by pushing the vehicle when the battery is at least still be able to explain the big lights.
- First, turn on the switch and then seek the assistance of two or three people to push your vehicle to the next. When the vehicle is moving pretty quickly, then release the pedal. When the engine is able to work, immediately push the accelerate pedal to increase engine torque. Using the same procedure, the car can also be turned on by another vehicle pulled. Procedures of both can not be used for automatic car.
- Another way is to start the engine with the help of a battery from another vehicle. If there is anyone with a good battery and a long enough cable available, then the engine will start to connect the positive terminal to the positive and negative to negative from both the vehicle. This method can be done when both batteries have the same power.
Now they go on a mission to track down issues. In such circumstances, the potential damage is damage to the starter motor, starter motor gear or the wheel broken.
The incident is not the first time that happened. In other instances when the contact switch is turned, the starter motor spins the engine works and axle fast but the engine is not able to function or when the switch contacts starter spun, the engine will not run properly function and then die suddenly.
In both cases, they may be faced with damage to the fuel delivery system (fuel system) or the ignition system. When the starter motor to rotate the axle works and engine, but the engine can not function, then it shows the damage did not occur in batteries and equipment start. Usually, when the compression process will run smoothly, the engine will not suddenly break down. Thus, the damage should be sought on transmission systems and ignition system.
When the situation happened, things that should be checked are: is the oil in the tank, is enough oil in the carburetor? If enough, this means that the damage may be located on the ignition system. If the spill was (carburetor wet), the engine difficult to start for oil in the combustion chamber is too much. Usually occurs because the oil spill off the handle needle oil entry into a float (the carburetor) does not work, probably because of dust stuck. If the spill is on the engine failure, remove the oil from the carburetor, clean the dirt in the needle and re-close the oil.
The engine of the carburetor overflow can be switched in the following way. Accelerate pedal fully, run the starter motor. The oil in from the carburetor to the cylinder through the suction channel can be removed and then the engine will work. Control pedal such that rotation of the engine oil is too high.
Even so, it's possible the engine can not function, whereas regular carburetor overflow. In this case, if do not know the correct yourself, it is best brought to the workshop for repair.